Philly Funk – Sour IPA

Brew

Hops

Hop60min10min0minDHTotal
Citra305050130
Mosaic10305050140
Total1060100100270
WP @80C for 20min, DH day 6

Grain

  • 4.7kg Gladfield American Ale
  • 0.65kg Gladfield Munich
  • 0.65kg Gladfield Pilsner

Yeast

1.5 packets Philly Sour

Water Treatment

2g Calcium Chloride (CaCl2), 4g Magnesium Sulphate (Epsom salts – MgS04), 8g Calcium Sulphate (Gypsum- CaSO4)

Boil Additions

2g YN, 1g WF @ 10min

Brew

  • Mash in at 65°C with 16L, rest for 60 min at 65°C.
  • Mash out: 10min @ 76
  • Sparge with 16L at 76°C
  • Preboil size 28L
  • Boil time 60mins
  • Fermenter volume 22L

Fermentation

Ferment for 48hours @ 20C, then raise 1C every 24 hours until 23C. Hold at 23C for rest.

Fermenter Additions

Dry Hop day 7-8

Carbonation

Day 6 CO2 capture after dry hop.

Bottled

N/A

Final Volume

21L

Notes

First attempt of a Sour IPA using philly sour yeast. Mosaic and Citra hops, american ale, munich and pilsner grain.

This Sour IPA combines the fruity tropical flavors of Mosaic and Citra hops with a crisp, light body achieved through Gladfield’s malts. Philly Sour yeast adds a clean, refreshing tartness for a balanced and highly drinkable brew.

Fermentation Schedule

Day 1–2: Ferment at 20°C.

Day 3: Raise to 21°C.

Day 4: Raise to 22°C.

Day 7-8: Add dry hops (50g Citra + 50g Mosaic) and raise to 23°C.
Close spunding valve for CO2 capture

Day 8-11: Hold at 23°C to allow biotransformation and dry hop extraction.

Day 12-14: Cold crash to 3-4°C for 2 days.

Final pH: 3.7 (using digital pH meter)

Days 1 – 5

Brew went well. Pitched 1.5 packets (weighed the first packet until it was half gone) and set the fermenter to 20C.

Some movement over the first few days, approx 7 pts drop (showing around 1%) during the lactic acid phase so I’ll look to subtract this off the total percentage ABV estimate at the end.

SG at 1.048 until day 6…

I raised the temp as per the schedule to 22C, but didn’t raise to 23C as I wanted this to be the final change after fermentation was finished and I dry hopped.

Day 6

Finally started to see activity (foam on the top formed, and the galactic movement in the wort increased to a full activity level). Issues with the connection of the temp controller meant i haven’t logged gravity with the pill, but it was at 1.048 until day 6. then it moved quickly down and is rounding off on day 7 at approx 1.016 showing 5% abv, therefore around 4% abv at this stage – hopefully it drops further to dry the beer up a bit.

Day 7

Dry hop added end of day 7, closed spunding valve. SG moved down to 1.012 with the dry hop addition, but settled back to 1.015 (on track with existing trajectory) by the next morning.

Day 8

Raised temperature to final 23C for rest phase. Pressure already up to 14psi. SG 1.015 and dropping slowly (approx. a point a day)

Days 9-14

Pressure increased and held up around 29psi, gravity dropped approx 1.4pts per day to a final of 1.009. SG change shows 6% ABV – however sour phase shows nearly 1% of gravity change on the pill graph, I’ve estimated final of 5% to take this into account.

Pulled a 1.25L riga off for tasting – very clean nice sour taste, not too strong. Good hop aroma and IPA flavour. Overall very happy with the brew.

Remotely cooling from 23C, approx 2C per 12 hours until I get to 4C. Pill battery very low so it might switch over to the probe – shouldn’t matter as it’s simply keeping it cool now until I’m back from holiday.